How To Flash Intex Aqua N11 MTK Smartphone With SP Flash Tool

Sep 9, 2015

How To Flash Intex Aqua N11 MTK Smartphone With SP Flash Tool

Author: rizwana | September 09, 2015 | No comments |

Unofficial support site for this Phone By Welcome Zone Haldwani

The Instructions Given Below To Flash Stock Rom Or Any Custom Rom Flash File Firmware using Smart Phone Flash Tool (SP Flash Tool) on Your Android MTK SmartPhone .

Requirements:
1=> Your Android Smartphone should have at-least 40-50 percent of battery to perform the Flashing Process.
2=> SP Flash Tool And Usb Drivers .
You Can Download It From Last In The Post
3=> USB Cable.

Step 1: Download and install Android USB Drivers on your computer From The Link Given Up. In case You Already Installed Android USB Drivers on your Computer then skip this step.

Step 2: Then Next Step Is Power Off your Android Smartphone and remove the Battery (if it is removable).

Step 3: Download And Extract the Stock Rom or Custom Rom that you want to Flash on your Smartphone .

Step 4: Download and Extract Smart Phone Flash Tool on Your Computer. After Extracting you will be able to see the following files.

Step 5: Now Open Flash_tool.exe .

Step 6: When Smart Phone Flash Tool is launched , Click on the Scatter-Loading Button That Is On Right Side .

Step 7: Now , Locate the Scatter File (Give The Path Of That File You Extracted In Your Computer).

Step 8: Then Next Is Click on the Download Button to begin the Flashing Process.

After Clicking On The Download Button You Can See This Type Of Screen .

Step 9: Now, Connect your Android Smartphone to the Computer Via USB Cable (without battery- if it is removable).

Now One Red Line Is Run ThenThen One Voilet Line Then One Yellow Line Is Run And Then It finished .

Step 10: When Flashing is completed, a Green Download Ok Logo will appear.

Step 11: Now You Can Close the Smart Phone Flash Tool In your computer and disconnect your Android Smartphone from the computer .

Note => If You want To Flash Only User Data Or Recovery File So Tick Mark Only User Data Or Recovery File .
Deselect all parts except those one you want to flash and then press F9 Or Hit Download Button .

When You Click On The Download Button , The tool will immediately show a warning Message because not all parts are selected, but you should continue anyway, Safely press Yes.